Instruction manual

PANEL DESCRIPTIONS
FRONT PANEL
q
IR Window: IR receiver for signal from the device’s remote control or external IR controller
w
Power
• ON/OFF: Press this button to power On the device or set it to standby mode.
• Factory reset to default: Press and hold Power button then connect power to reset the system to Factory default settings.
e
MENU:
• Press this button to bring up the OSD (On Screen Display) menu on screen.
• Press “MENU” with “-“button to switch output timing to 720p@60Hz instantly.
• Press “MENU” with “+” button to switch output timing to XGA (1024x768@60Hz) instantly.
r
-/+ Buttons: Press these buttons to scroll down/up on the OSD selections then press “MENU” button to conrm.
t
CHANNEL INPUT 1~4 and CHANNEL OUTPUT A~D:
• Matrix mode:
• Press “Matrix/Dual/Wall” button repeatedly until the LED illuminates steady. You are now in Matrix mode.
• Press an output from A~D and then press corresponding input from 1~4. For example: press output A then press input 2, Will
result in Output A will display input 2’s image. Each output setting must be made individually.
• Dual mode: To combine 2 sources to be presented on each HDMI output ports (Dual A and Dual B).
• Press “Matrix/Dual/Wall” button repeatedly until the LED extinguishes. You are now in Dual mode.
• Press output A/B and then press corresponding input 1/2. For example: press output A then press input 1, output A will display
input 1’s image on the left side, then press output B and then press input 2, output A will display input 2’s image on the right
side. Both output A and B will have identical images.
• Dual A group are outputs A and B, Dual B group are outputs C and D. Each group will output the same image simultaneously.
• Press button A or B for 3 seconds, to switch Dual A channel’s audio between output A or B.
• Press button C or D for 3 seconds, to switch Dual B channel’s audio between output C or D.
• Video Wall mode:
• Press “Matrix/Dual/Wall” button repeatedly until the LED blinks constantly. You are now in Video Wall mode
• Press input 1~4 to select a source to 4 displays (2 x 2 Video wall). The audio will be on output A only.
y
MATRIX/DUAL/WALL: Press to switch between Matrix mode, Dual mode and Video Wall mode. The button LED will indicate which
mode you are in. Matrix mode: LED illuminate constantly.
• Dual mode: LED will extinguish.
• Video Wall mode: LED will blink constantly.
u
LOCK: Press once to lock the keypad and remote control, press and hold for 3 seconds to release the lock function.
i
SAVE: To save an Input and Output conguration to recall later:
• Press “Matrix/Dual/Wall” button to select mode status.
• Press each output channel A~D and the corresponding input channel 1~4.
• Press “SAVE”, the input 1~4 LEDs will all illuminate at the same time. Press input 1,2,3 or 4 to save to the system memory location.
• For example: Select Matrix mode, press output A then press input 4, then press “SAVE”. This will save the corresponding setup
for later recall using the front panel or the remote control FAV.1 thru FAV.4 buttons.
o
RECALL: Press “RECALL” and the input channel 1~4 LED will illuminate at the same time. Select input channel 1,2,3 or 4 to recall
the customized screen setting. Or using the remote control FAV.1~FAV.4 buttons.
3