Instruction manual

OSD MENU
OSD OPERATION
Main Menu Sub Menu Adjustments Default
BEZEL CORRECTION
(*7)
CORRECTION ON, OFF OFF
H CORRECTION 0 ~ by output resolution 0
V CORRECTION 0 ~ by output resolution 0
EXIT
RECALL / SAVE
(*8)
RECALL CANCEL, FAV.1~ 4 CANCEL
SAVE CANCEL, FAV.1~ 4 CANCEL
EXIT
ETHERNET IP MODE DHCP, STATIC DHCP
STATIC SET IP, MASK, GATE IP
BYTE1 192
BYTE2 168
BYTE3 5
BYTE4 155
RE-LINK(*9)
TIMEOUT (Min.)(*10) 5~60, OFF 10
EXIT
OTHERS IR ADDRESS(*11) 0 ~ 3 0
EXIT
FACTORY DEFAULT EXIT YES, NO NO
EXIT
INFORMATION
(*12)
IN/OUT RESOLUTION,
SOURCE HDCP/AUDIO,
OUT MODE, FIRMWARE
VER
EXIT
EXIT
Note:
*1 Picture: In Matrix mode, four pictures adjust simultaneously. In Dual/Video Wall mode, each picture can adjust individually and support individual last
memory feature.
*2 Output: In Video Wall mode and Dual Mode, Output resolution 1080i@50Hz and 1080i@60Hz are not supported.
*3 AUDIO EDID: Embedded input audio EDID contents, LPCM 2CH = LPCM 2CH LPCM 6CH = LPCM 2CH/ 6CH LPCM 8CH = LPCM 2HC/ 6CH/ 8CH
BITSTREAM = LPCM 2CH, AC3, DTS HD = LPCM 2CH/ 6CH/ 8CH, AC3, DTS, Dolby Digital Plus, DTS-HD
*4 TIMEOUT: OFF means MENU and INFO will show continuously on the screen
*5 HDCP INPUT: ACCEPT: Support HDCP source, this is default setting. NOT ACCEPT: Not support HDCP source.
For example: Apply source.
*6 HDCP OUTPUT: FOLLOW INPUT: If source with HDCP the output will support HDCP. If input source without HDCP the output will not support HDCP.
When in Dual mode, one of each side (Left or Right) support HDCP, the output will support HDCP. ALWAYS ON: All the displays need to support HDCP, to
avoid switching source from non-HDCP to HDCP, or ashing image or no image.
*7 BEZEL CORRECTION: Only supported in Video Wall mode, after adjustment the system will support last memory function.
*8 SAVE/RECALL: To SAVE/RECALL input/output setting, the system support last memory function to save all settings.
*9 Ethernet RE-LINK: After the setup, need to RE-LINK the system and re-connect the system again.
*10 Ethernet TIMEOUT: Select OFF to end the time out function or when telnet is under idol without sending commands within the time out setting the
telnet system will be terminated.
*11 IR ADDRESS: This setting is to match the IR remote control dip switch. Refer to section x.x for remote control settings.
*12 INFORMATION: To show Input/Output/Audio/Mode/Firmware information.
11