User`s manual

USER’S MANUAL OF WNAP 3G MOBILE ROUTER Version: 1.4
36
PPPoE protocol whenever this Router is powered on.
Connect on Demand connection type means to setup the connection
through PPPoE protocol whenever you send the data packets out
through the WAN interface; there are a watchdog implemented to close
the PPPoE connection while there are no data sent out longer than the
idle time set.
Manual connection type means to setup the connection through the
PPPoE protocol by clicking the Connect button manually, and clicking
the Disconnect button manually.
Idle Time If you select the PPPoE and Connect on Demand connection type, fill
in the idle time for auto-disconnect function. Value can be between 1
and 1000 minutes.
MTU Size Fill in the mtu size of MTU Size. The default value is 1452. Refer to
4.23 What is Maximum Transmission Unit (MTU) Size?
Attain DNS
Automatically
Click to select getting DNS address for PPPoE support. Please select
Set DNS Manually if the PPPoE support is selected.
Set DNS Manually Click to select getting DNS address for Static IP support.
DNS 1 Fill in the IP address of Domain Name Server 1.
DNS 2 Fill in the IP address of Domain Name Server 2.
DNS 3 Fill in the IP address of Domain Name Server 3.
Clone MAC Address Fill in the MAC address that is the MAC address to be cloned. Refer to
4.24 What is Clone MAC Address?
Enable uPNP Click the checkbox to enable uPNP function.
Refer to 4.22 What is Universal Plug and Play (uPNP)?
Enable IGMP Proxy Click the checkbox to enable IGMP Proxy.
Enable Ping Access on
WAN
Click the checkbox to enable WAN ICMP response.
Enable Web Server
Access on WAN
Click the checkbox to enable web configuration from WAN side.
Enable FTP Server Access
on WAN
Click the checkbox to enable FTP Server Access on WAN
Apply Changes Click the Apply Changes button to complete the new configuration.
Reset Click the Reset button to abort change and recover the previous
configuration setting.