Instructions / Assembly

Step 4. Install the panels on the wall or ceiling
Glue the panels directly onto the wall using a multi-purpose adhesive for polystyrene
foam. Apply the adhesive evenly onto the surface, either in spots or all along the edge
of the panel, about 1 inch from the edge (the reverse side of the panel), and on the
contact edges of the panel. Now press the panel gently onto the surface. Use a damp
cloth to remove any excess amount of the adhesive. When placing the panels onto the
wall, make sure that all the edges adhere properly to the surface. If you discover any
cracks in the joints on the panels, use an acrylic filler.
Apply an acrylic filler in all cracks. Apply an acrylic filler in all cracks and use a plastic
putty knife to remove any excess amount of the filler material to give the surface a
uniform decorative look.
Step 5. Painting
Before painting the panels, it is best to wait for at least 24 hours to allow the adhesive
acrylic filler material to dry. using commercial acrylic or latex paints for indoor use, paint
the panels twice.
NOTE!
• Do not press the panels onto the wall too hard, as this may damage them.
• Use only proven, high quality paints - for good coverage.
• Use an adhesive for polystyrene foam. Consider buying it from us, as we can
help you choose the right adhesive for the products.
• Remember to cut the panels only with a sharp wallpaper cutter.
• After painting, use a feather duster or vacuum cleaner with a soft brush
attachment to clean the panels.
Do not install the panels in busy areas. Choose surfaces away from an open flame and
high temperatures (e.g. a fireplace, a gas cooker etc