OWNER'S MANUAL & OPERATION INSTRUCTION 9000 Starting Watts 7000 Running Watts PORTABLE GENERATOR MODEL NUMBER Visit Our Website at: http://www.a-ipower.com SUA9000E Email Our Technical Support at: support@a-ipower.com FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598 SAVE THIS MANUAL This manual contains important information regarding safety, operation, maintnance and storage of this product. Before use, read carefully and understand all cautions, warnings, instructions and product labels.
3 13 3 13 13 6 6 13 6 13 13 7 14 4.4 Wattage Reference Guide 9 14 9 14 9 14 9 15 10 15 10 16 10 18 12 19 12 12 Parts list and Diagram 12 20 24 12 WARNING The Engine Exhaust from this product contains chemicals known to the State of California to cause cancer or birth defects and other reproductive harm.
A-iPower. Please call our Customer Service at 1-855-888-3598 for starting, operating and servicing procedures. We also strongly recommend you to instruct any other users who may operate the generator in an emergency. A-iPower SECTION 1 SAFETY RULES Failure to follow instructions could result in serious injury or death.
please call our Customer Service at 1-855-888-3598.
SECTION 2 SET UP INSTALL THE WHEEL KIT Wheel kit Support Leg Other 2- 9.5 in wheel 2 -axle pin 2- pin 4- washer 1- support leg 2-flange bolt (M8x16) 2- nut (M8) 1- engine oil 1.0 Quart 1- DC charge cable 1- spark torch 1- extension bar 1- high altitude kit The above mentioned parts are packed in one box. Ensure you have all included items prior to assembly. If items are damaged or missing, call 1-855-888-3598. INSTALL THE SUPPORT LEG (M8) 6 2.2.
GENERATOR 1 2 3 4 5 6 7 1. Fuel Tank - 7 gallon (25 L) capacity fuel tank. 2. Choke Lever - Controls choke valve. Used when starting a cold engine. 3. Air Filter - Protects the engine by filtering dust and debris from the intake air. 4. Fuel Valve - Used to turn fuel supply on and off to engine. 5. Recoil Starter - Used to manally start the engine. 6. Oil Filler Cap - Check and fill engine oil level. 7. Control Panel - See "Power Panel" section on Page 8.
CONTROL PANEL 1 2 5 6 3 7 4 8 9 10 1. Hour Meter - Monitor run time and schedule maintenance intervals 2. Low Oil Alarm - Alarm when low oil is detected 3. Circuit Breaker - The circuit breadker protects the generator against electrical overloads. The rating of the breaker and the load it protects are marked near the breaker. Should any of the Circuit Breakers trip, the generator will stop the electricity output. If this happens, unplug all loads from the generator.
The SAE Viscosity Chart 9
4.4 WATTAGE REFERENCE GUIDE Fuel Valve START Turn Fuel Valve to ON position.
starts Push the switch to “START” position, hold in start position until generator start. Caution: to prolong the life of starter components, DO NOT hold for more than 10 seconds. Pause and retry as necessary. After generator starts, release switch and it will return to the “ON” position automatically.
: Volts x Amps = Watts The “WATTAGE REFERENCE GUIDE”on Page 10 helps to determine how many items the generator can operate at one time. turn Engine DO NOT overload Generator Capacity HIGH ALTITUDE OPERATION At high altitudes over 3,000 feet, the engine carburetor and any other parts that control the fuel-air ratio will be affected, which will decrease performance, increase fuel consumption and increase emission.
“MAINTENANCE” section 13
CHANGING ENGINE OIL engine If running this unit under dirty or dusty conditions, or in extremely hot weather, to change the oil more often.
Valve Clearance - Intake: 0.10-0.15mm（0.004-0.006 in） - Exhaust: 0.15-0.20mm（0.006-0.
Problem Engine will not start Possible Causes FUEL RELATED: 1. No fuel in tank or fuel valve is in “OFF” position. Probable Solutions FUEL RELATED: 3. Choke not in START position, cold engine. 1. Fill fuel tank with fresh 87+ octane unleaded stabilizer-treated gasoline and turn fuel valve to “ON” position. Do not use gasoline with more than 10% ethanol (E15, E20, E85, etc.). 2. Drain fuel tank and carburetor; fill with fresh fuel. 3. Move Choke to START position. 4. Carburetor not primed. 4.
Problem Engine misfires Possible Causes 1. Spark plug cap loose. 2. Incorrect spark plug gap or damaged spark plug. 3. Defective spark plug cap. 4. Old or low quality gasoline. 5. Incorrect compression. Engine stops suddenly 1. Fuel tank empty or full of impure or low quality gasoline. 2. Low oil shutdown. 3. Defective fuel tank cap creating vacuum, preventing proper fuel flow. 4. Faulty magneto. 5. Disconnected or improperly connected spark plug cap. Probable Solutions 1. Check wire connections. 2.
Model Number SUA9000E Starting Watts 9000 Running Watts 7000 AC Load 120/240V Frequency 60Hz Running VAC Amperage 29.0A Phase Single IP Class 21 Power Factor 1.0 Generator ONE - 120V AC 30A L5-30R Receptacle FOUR - 120V 20A NEMA 5-20R GFCI Outlet ONE - 120/240V 30A NEMA L14-30R Outlet Displacement 420cc / 14hp Starting Method Electric Cooling System Horizontal Single Cylinder 4 Stroke OHV Fuel Tank Capacity 7Gl. (25L) Engine Oil Capacity 1.0Qt. (1.
DIAGRAM SUA9000E SECTION 10 19
SECTION 11 PARTS LIST AND DIAGRAM GENERAL PARTS LIST 20 Part Discription QTY Part 1 Nut, Flange 4 32 Hexagon Blot 2 2 Nut, Flange 4 33 Bolt,Flange 4 3 Shock Absorbing Mount 4 34 Motor Bracket 1 4 Washer, Plain 4 35 Wiring Borad Assy 1 5 Wheel Assy 2 36 Bolt,Flange 5 6 Axle 2 37 Carbon Brush 1 7 Clip, Dowel Pin 1 38 AVR 1 8 Positive Charging Wire 1 39 Motor Cover, Rear 1 9 Negative Charging Wire 1 40 Washer, Plain 1 10 Bolt,Flange 9 41 Bolt,Fl
GENERAL DIAGRAM 21
ENGINE PARTS LIST Part Qty Part 2 Bolt Cylinder Head Cover Assy 1 1 46 47 Bearing Crankshaft Assy 2 1 3 4 5 Exhaust Pipe Gasket, Cylinder Cap Bolt,Flange 1 1 12 48 49 50 Gasket, Crankcase Cover Dowel Pin Crankcase Cover Assy 1 2 1 6 7 Air Deflector 1 51 Bolt,Flange 7 Regulating Nut, Rockshaft 8 Rockshaft 2 2 52 53 9 10 11 12 Rocker Arm Bolt, Rockshaft 2 54 Oil Seal Bearing Dipstick 2 1 1 2 1 1 55 56 57 Bolt,Flange Engine Oil Sensor Gestket, Rod 2 1 1 1 58 Oil Seal 1
ENGINE DIAGRAM 23
12 2016 2017 24
A-iPower A-iPower's only liability shall be the repair or replacement of part(s) as stated above in no event shall A-iPower be liable for any incidental or consequential damages.
A-iPower Limited Warranty Policy Thank You For Choosing A-iPower Generator! Our Warranty A-iPower will, at its position, free of charge, repair or replace any part(s) which, upon examination, inspection and testing by A-iPower or an A-iPower authorized warranty service dealer that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. Retain your proof-of-purchase receipt.
855-888-3598,626-225-8930
