Owner's manual

SECTION 2 —GENERAL INFORMATION
2.1 UNPACKING
• Set the carton on a rigid, flat surface.
• Remove everything from carton except
generator.
• Open carton completely by cutting each corner
from top to bottom.
• Leave generator on carton to install wheel kit.
2.1.1 PACKING CONTENTS
1-Owner’s Manual
2-Wheels（
For 2.5kW and up）
1-Handle Assembly（For 2.5kW and up）
2-Wheel Axle（For 2.5kW and up）
1-Hardware Bag
(Including 1-Spark Plug Socket; 1-Extension)
2.2 ASSEMBLY
The generator requires some assembly prior to
locknut
support
rubber pad
flange bolt
using it.
2.2.1 ASSEMBLING THE ACCESSORY
KIT
The wheels are designed to greatly improve the
portability of the generator.
Refer to Figure to install wheels as shown.
Refer to Figure to install the leg supports as
shown.
The wheels are Not intended for
over-the-road use.
4
battery
• Slide the axle through the wheel hub, then insert
the flat washer.
• Slide the axle through the frame brackets.
• Bend the cotter pin tabs outward to lock the pin
in place.
• Unscrew nut on leg support, install bolt through
the generator frame, secure the bolt tightly with
wrench(not included).
REMOVE Red Support Bracket Before Use! (It
is a packing material, will damage engine without
removing it.)