A\POWER GAS PRESSURE WASHER 3100 P81, 2.4 GPM Model: PWF3100YV CUSTOMER SERVICE: 1-855-888-3598 Visit Qur Wishlist's at: Email Our Technical Support st com NOTICE: Do not use E85 or E16 fue! in this product. It can damage the engine and void your warranty. Only uss Blindsided gasoline containing up fo 10% analyst. O®® A-i Power Corp. Montana, CA 92337 USA A WARNING: SAVE THIS MANUAL FOR FUTURE REFERENCE ‘This manual contains important information regarding safety.
Moet PWF3100YV Pump Axial Maintenance Free Drive Vertical Shaft Direct MAX Pressure 3100 PSI MAX Flow 24 GPH Hose 174 x 25" M22 Wand 217 x 114 QIC Nozzle Selection QUG 0, 15%, 28°, 40°, Cap Nozzle Atwood MA120 Displacement 189¢c Engine Ty pa Single Cylinder 4-Stroke OHY Canoeing System Air Cooled Oil System Splash imbrication Fuel Type 87+ Octane Unleaded Gasoline Fuel Capacity 0.48 Gallon (1.8 Liter) Engine Ol Type 10W-30 Engine Qil Capacity | 0.6 Quart (0.
This Ingratiating Manual has bean designed fo instruct you on the correct operation of your A4 POWER product. Your satisfaction with this product and its safe operation is our ultimate concern. Therefor, please task the time to read the entire manual, especially the safety symbols and instructions They will help you to avoid potential hazards that may exist when working with this product. Every effort has been made o ensure that information In this manual Is accurate and current.
important Operation instructions and Precautions: A DANGER: poisonous Gas HAZARD Engine exhaust contains carbon monoxide, a poisonous gas that WILL kil you in minutes. You CANNOT small it, sue i, or taste it. Even if you do not smell exhaust fumes, you could still ba exposed to carbon monoxide gas.
A WARNING: READ AND UNDERSTAND ALL SAFETY INSTRUCTIONS » Keep guards in pace and in working order. Never aerate this product with any guard or cover removed. Make sure all guards are Intact and aerating properly before each use » Remove adjusting toots and wrenches, If any adjustments or maintenance has been performed, make sure that all tocsin and adjusting wrenches are removed from product before uss. » To reduce the reek of Injury, keep alf children and visors away from product when In use.
&} WARNING: Fire / Hot Surface Hazard 1% Exhaust could ignites combustibles, resulting in death or serious injury Contact with muffler area could cause bums resulting in serious injury. = DO NOT touch hot parts and AVOID hot exhaust gases » Ali ow equipment to cool before touching. « Keep at least 5 feet renaissance on all sides of pressure washer including overhead.
&b WARNING: Fire / Explosion Hazard fi Fuse and ke vapors are extremely flammable and explosive which could = cause bums, fire or explosion resulting in death or serious injury. Risk of fire and rotisserie burns: Never remove fus! cap when unit is running. Shut off engine and allow the unit to cool at least five minutes. Remove cap slowly. WHEN ADDING OR DRAINING FUEL « Tum surpass washer engine OFF and let it coo! at least 2 minutes before removing fuse cap.
£) warning: Fluid injection % The high-pressures swab that this equipment produces could cut through skin and its underlying tissues, resulting in serious injury and possible amputation. Spray gun traps high water pressures, #van wham engine is stopped and water is disconnected, which could result in serious injury. ¥ out by fluid, call physical immediately. DO NOT treat as a. simple cut, DO NOT allow CHILDREN to separate pressure washer. NEVER repair high pressures hes.
&b WARNING: Electrical Shock &3 WARNING: Chemical Bum Contact with power sours could Chemicals could cause bums . cause strict shock or burn resulting in death or serous = resulting in death or serious injury. injury. + DO NOT use caustic liquid with Never spray at or near an electric pressure washer. pews source. + Uss ONLY pressure washer safe detergents/soaps. Follow all manufacturer’s instructions.
caution: Read Manual Read the entire SAFETY action at the beginning of this manual including all text. under subheadings therein before chef-up or use of this product. Know your Pressure Washer Foam Grip Pressure Hose Re coll Handle : Spray Gun Wand | ;&A A Fuel Tank | L Air filter ACCESSORIES INCLUDED: * 0.
ASSEMBLY: 1.Push and hold the button on the handle as 4. Connect the Pressure Hose to the Pump you skis the hands into the holes in the frame, and then inert screw through the. holes in the hands and the pressures washer farms, pace nut onto screw and tights securely. See Figure A. 2. Attach the gun holder assembly o the frame,install the lock nut, wrench tighten until the nut is snug. {Rotate the holder according to the need ) See Figure B. 3. nevertheless hose holder Inst the hales on the back of panel.
6. Attach the Nozzle to the Wand by 7. Compact the warts supply hiss to the puling back the quirk connect collar water inlet connection on the Pump snd and pushing the Nozzle anti the end of tighten the Inst Fitting firmly by hand. the Wand. Make sure the Buick connect See Figure H. collar locks the Nozzle in place. The water source must be able to Ses Figure G.
GENERAL INFORMATION: High Pressure | There are no serviceable parts to the high-pressure pump. Do not Pump attempt to repair or services the pump, as you may damage i and void your warranty. If you feel that the pump needs service, please call our customer service department at 1-855-888-3598. Do not allow water to freeze in pump. If product is stored in an area that will have temperatures of below 32° F, 0°C, make sure all water is removed from the pump, of a suitable pump protection product has been used.
CAUTION: Read Manual Read the entire SAFETY and SET UP sections at the beginning of this manual including all text under subheadings therein before operation of this product. Improper use or treatment of Pressure Washer can damage internal components and shorten the rife of unit. Failure to folio this warning will cold warranty. Pr-Start Hacks inspect engine and equipment rooking for damaged, noose and missing parks bafflers setting up and starting.
Pr-Start Checks (Continued) &) WARNING: Fire / Expulsion Hazard fl Fuel and fuse vapor are trammel flammable and explosive. Fire or explosion * frown misuse of fuel can cause severe bums and even death. « Fi the fue! tank in 8 well-ventilated areas sway from ignition secures. if the engine is hat from use, shut the engine off and wait for it to cool before adding fuel. « Do not smoke near open fuel tank or container. « Failure to use fuel a8 recons mended in this mandamus will void the warranty.
Starting the Engine &b caution: Read Manual Read the stirs Pr-Start Checks section of this manual before attempting to start the engines. Be sirs te inspect the equipment and engines for any missing or loos guards or parts. Check both the fuse and oil levels of the engine before starting. * Turn fuse naive to open, if so skipped » Turn on water supply, remove nozzle, point wand in safe direction, and hold down trigger until all air is released from the system, at least 30 seconds.
Pressures Washer Operation &) WARNING: Eye protection / Fluid Injection hazard fl % ALWAYS wear approved safely glasses when operating Pressure ‘Washers. Spray can splash back or propel objects, including incompletely attached accessories. The high-pressures stream of warts that this equipment produces can cut through skin and its underlying tissues, shading to possible amputation. The spray gun traps high water pressure, even when the motor is stopped and water source is disconnected, which can cuss injury.
154 footie ©° Nozzle Red: This nozzles delivers a pinpoint stream of pressurized water and is extremely powerful. Uss it for the toughest cleaning jobs, though it covers only & small area. This nozzles should only be directed at surfaces that can withstand intense high pressure such as natal or concrete. Do not uss this nozzle to clan wood or soft surfaces. 15° Nozzle Yellow: This nozzle delivers a 15-degree spray patient for heavy duty cleaning and stripping.
3. Using the Spray Gun. A VARNISHING: « To prevent accidental discharge of pressurizer washer, the trigger lock on the rigger should be engaged whenever the pressure washer is not in use. To disengages the Trigger Lock, push the lock down and inf its origins! position To Operate the Trigger: 31 Squeeze the trigger to start water flow through the nozzles 32 Reseals the trigger 1o stop water flow. 4 WARNING: Hat Surface / Fluid Injection hazard SOME ENGINE ! &55 PARTS CAN BECOME — EXTREMELY HOT.
L] L barb near the high-pressures hose inaction area of the pump 67 Sub meme the strainer end of the siphon tubs in the soap/detergent solution bottle or bucket. .8 Change the nozzle to black nozzle 6.8 Start engines and spray with soap. 7.To Rinse 7.1 Replace the nozzle with an appropriate high-pressure nozzles (see “Selecting The Right Nozzle” on Peg 777). Squeeze the trigger and wait for the detergent to sear. 7.2 Esp ths spray gun a see distances from the area you pain to spray 7.
Pump Maintenance NOTICE: The pressures pump is maintenance free. If you tonics any sign of il leakage in and around the pump, DO NOT operate the pressure washer. Fleas call our Customer Services af 1-855-8883588, Cleaning Nozzle: Occasionally, the spray wand can become clogged with foreign materials such as dirt Y When this happens, excessive pressures oan develop. Whenever tha pressure nozzle becomes particularly clogged, the pump pressure will pulsate, It shooed be immediately cleansed. 1.
5. Remove tha drain pig end, if possible, tilt the crankcase sightly to help drain the vil out riot the pan. Recycle used 8. Replaces the drain plug and tights &. 2. Adding Engine OIl: [ Spark Plug Maintenance: . Disconnect spark plug cap from end of plug. Clean out debris from around sparing plug 2. Using a spark plug wrench, remove ihe spark plug .
Alr Flits Maintenance: 1. Remove the Alr Filter Over and the &ir filtrates) and check for sift. Clean as described blow. Cleaning: For paper filters: Te prevent injury from dust and debris, wear ANSI-approved safely goggles, NOSH-approved dust respiratory, and heavy-duty work gloves. In & well-ventilated tires away from bystanders, use pressurized air to Blow dust out of the fighter.
Storing Accessories ‘The Pressure Washer is equipped with places to store your accessories as shown (ses diagram on page 8). 1. Claps Spray Gun into Gun Holder 2. Claps nozzles in the top pans. 3. Colt and tis Pressures Hose and hang on the hos hanger. Pump Preparation 1. Disconnect the high-pressure hose and the water supp'y hose from the pump. 2. Pull starter rope handle several times to expel water from the pump. NOTICE: It is normal to see water exi both inlet and outset of pump during this narcissus.
Troubleshooting Pol e LSl Engine will | No fus! in tank or fuel valve is in not start. “OFF" position. LR T Fill fuel tank with fresh 87 + octane unleaded stabilizer-treated gasoline and tum fuel velvet to “ON" position. Do not use gasoline with more than 10% ethanol! (E18, E20, E35, etc ). Low quality, stale, dirty or deteriorated gasoline Drain duet tank and carburetor; fill with fresh fuse, Choke not in START position, cold engine. Moe Hoke to START position. Carburetor not primed.
Troubleshooting continued LTI S Engine will | Loose or broken spark plug. Tighten spark plug. If that does net not start | (Hissing anise will occur when frying | work, replace spark plug. {cont). to start) if problem portraits, may have head gasket problem Loose cylinder head or damaged | Tighten head. head gasket. (Hissing noise will If that does not remedy program, recur when trying to start) replicas head ascetic Engine valves or tappets miscall customer service at: adjusted or stick 1-855-888-3598.
L Lme Qry Part. .
LIMITED WARRANTY KEEP YOUR RECEIPT. Proof of purchase will be required to substantiate any warranty claim. WHAT 18 COVERED: A-i Power Corp.
WARRANTY STATEMENT L] DO HOT RETURN THE PRODUCT TO THE PLACE OF PURCHASE A-i Power Customer Service Apt will assist with all product related questions and will help troubleshoot issues and wil send any entrancement parts 8s necessary while product is within the warranty priced &t ne chars. If the issue canst be rescinded then A-Po war Customer Service Apt at its discretion determine and authorize diagnosis and repair trough one of its authorized Services Centers.
¥ ’ Register your product by emailing this form to com or register on-Ina st: Registering your product is important , it provides the following protections: 1. You have record of product purchased 2. Customer Service can Batter versa you for Warranty related issues 3. We can contact you In the unlikely event should notification Is necessary Purchase Date: 1.THE PRODUCT WAS PURCHASED FOR: AU Residential cleaning B. 2 Cather this PRODUCT I8 A: (select ons) AL First time purchase B.
