Full Product Manual

ManualsBrandsA-iPower ManualsGenerators7600-Watt Remote Electric Start Gas and Propane Powered Inverter Generator with 322cc OHV Engine and CO Sensor Shutdown

CONTROL PANEL FEATURES

Page 10

NOTE: Total power drawn from all outlets must not exceed the nameplate rating.

1. LED Data Center: See LED DATA CENTER section.

2. Push-Button START/STOP: Push once to automati-

cally start the engine. Push again to stop the engine.

3. Battery Switch: Restore the battery power to the

control module. you must turn the switch to ON position

before start the generator.

4. Remote Set Button: To pair the new remote control

fob.

5. Circuit Breaker(AC): Protects the generator against

electrical overloads.

6. Parallel Operation Outlets: These outlets are used

for connecting two AIPOWER inverter generators for

parallel operation. Do not connect or disconnect parallel

cables while the generator is running to avoid damage.

7. 120/240V AC, 30A Twist Lock, Single Phase,60Hz

Outlet (NEMA L14-30R): supply either 120 Volt or 240

Volt output up to 30 amps.

8. LED Light

9. 120V AC, 30A Twist Lock Outlet, Single pPhase,60

Hz Outlet (NEMA L5-30R): This receptacle can

provide120 volt output up to 30 amps.

10. Grounding Terminal: To ground the generator.

11. 120V AC, 20A Duplex, Single Phase, 60Hz Outlets

(5-20R): Each outlet is capable of carrying a maximum

of 20 amps on a single outlet or a ombination of both

outlets.

12. Voltage Selector Switch: To select 120 Volt or 240

Volt. Turn generator off before switching voltages.

15. CO (Carbon Monoxide) WATCH-GUARD Indicator

Light (Red for Shut off and Yellow for Service): The

CO(Carbon Monoxide) WATCH-GUARD monitors for the

accumulation of poisonous CO gas around the genera

tor produced by engine exhaust when the generator is

running. If the CO WATCH-GUARD detects increasing

levels of CO gas, it automatically shuts off the engine.

See CO WATCH-GUARD section for more information.

16. Starting Dial Switch: Used to start and stop the

generator.

14. 5V DC USB Outlets: Supply 3.6A USB-A type and

3.0A USB-C type for different applications.

1 2 3 4 5 5 6 6

791114 1316 15 12 10 8

13. 12V DC Battery Charger Inlet: Plug the battery

float charger to this inlet and 120V wall outlet to

charge the generator battery when the generator is

not running.