Full Product Manual

1. Data Center: Push the SELECT button to

display the voltage (V), frequency (Hz) and total

run time(Hour).

2. Circuit Breaker: Protects the generator against

electrical overloads.

3. 120V AC, 30A Twist Lock outlet, single

phase, 60Hz Outlet (NEMA L5-30R): This

receptacle can provide120 volt output up to 30

amps.

4. 120V AC, 20A Duplex, Single Phase, 60Hz

Outlets (5-20R): Each outlet is capable of

carrying a maximum of 20 amps on a single

outlet or a ombination of both outlets.

5. 120/240V AC, 30A Twist Lock, Single

Phase,60Hz Outlet (NEMA L14-30R): Supply

either 120 Volt or 240 Volt output up to 30 amps.

6. Grounding Terminal: To ground the generator.

7. Voltage Selector Switch: To select 120 Volt or

240 Volt. Turn generator off before switching

voltages.

8. Low Oil Indicator: The Light will be illuminated

when the engine oil level is low. Add oil.

9. CO (Carbon Monoxide) WATCH-GUARD Indica-

tor Light (Red for Shut off and Yellow for Service):

The CO (Carbon Monoxide) WATCH-GUARD moni-

tors for the accumulation of poisonous CO gas

around the generator produced by engine exhaust

when the generator is running. If the CO

WATCH-GUARD detects increasing levels of CO gas,

it automatically shuts off the engine. See CO

WATCH-GUARD section for more information.

10. Propane/LPG inlet: Used to connect

Propane/LPG hose to generator.

11. Fuel Source Switch: Used to select gasoline or

propane/LPG operation.Engine switch is ON when

the switch is on GAS or LPG positions.

Page 12

NOTE: Total power drawn from all outlets must not exceed the nameplate rating.

CONTROL PANEL FEATURES

1 2 2 3 4 2 4

22789