User's Manual

— 4 —
Inserting the Batteries
The RF-Mouse uses two AAA batteries. For
best performance, use only alkaline
batteries. Refer to the following to insert
the batteries:
1. Press the tab on the bottom of the
mouse cover as shown here and
remove the cover.
2. Insert the two AAA batteries. (The
correct polarity is indicated on the
battery compartment casing.)
3. Replace the cover.
Checking the Batteries power
To check the battery power, right-click the
mouse icon in the Taskbar. Choose the
“Check RF-Mouse Status” option to display
the RF-Mouse Status window. The current
battery percentage charge is shown.
Installing the Mouse Software
Before you can take advantage of the many features your mouse offers, you must
install the driver. The driver is on the installation diskette that came packaged with
your mouse.
Windows 95/98/2000/NT4.0 installation
1. Connect the mouse to your computer.
2. Insert the installation diskette into your floppy disk drive.
3. Click the Start button and then click Run.
4. In the Run dialog window, type A:\setup, where “A” is the letter of your
floppy disk drive.
5. Click OK and follow the instructions on your screen to complete the
installation.
The RF-Mouse ID code
Each RF-Mouse is assigned a unique ID code at manufacture, so the receiver only picks
up the signal from your mouse and prevents other RF-Mouse radio signals from
operating on your computer. This feature can also be disabled, allowing other RF-
pointing devices to operate your computer.
Connecting the RF-Mouse ID Code