User Manual www.a4tech.
Federal Communications Commission Requirements The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication.
Hardware Installation 1. Pull out the nano-Receiver from the bottom of mouse . 2. Plug nano-receiver into USB port of your computer or notebook. 3. Insert the supplied battery, making sure that the positive (+) and negative (-) ends of the battery match the polarity indicators inside the battery housing. and power will be automatically on. Now you can use the mouse.
Notice: To ensure a good wireless connection, please read below instructions for your reference: If the wireless mouse is not working smoothly due to wireless conflicts, try below methods to get improvement. A) Please plug the Multi-link receiver into of B) to avoid shielding wireless signal instead . Use USB extension cable to position the Multi-link receiver at a distance to prevent electromagnetism interference from devices. Troubleshooting & FAQ If the mouse is not working: 1.
