G6 Saver User’s Guide Keyboard & Mouse Dongle Model:RG-20KM www.a4tech.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Federal Communications Commission Requirements The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules.
Introduction: 2.4GHz wireless technology with 16 channels and 1,048,576 ID Errorless 2-Way Communication Technology Codes The 2.4GHz RF wireless technology is fine-tuned with 16 selected Errorless 2-way communication technology features error channels and exclusive 1,048,576 ID-codes; it offers precise and correction capability that speeds up data transmission and smooth wireless operation in active wireless environments. It allows increases wireless precision.
Specifications 2Mbps Frequency 2.402GHz～2.480GHz 1,048,576 sets Channels 16 channels RF Data Transmit Rate ID Codes Wireless Range Any electrical device, such as the computer monitor, Zip drives, speakers, etc., can cause interference with the wireless mouse/keyboard. Most likely, this will effect tracking of pointing devices or the range of the device. To make sure that your mouse/keyboard transmits and receives properly, refer to the following instructions: 1.
Hardware Installation Step 1: Inserting the Batteries A. Press the tab on the battery cover B. Insert the supplied batteries, making sure that the locates on the mouse/keyboard positive (+) and negative (-) ends of the battery bottom as shown here and match the polarity indicators inside the battery remove the cover. housing. C. Slide the batter cover back into its position until it “clicks” firmly into place.
Step 2: Connect the Receiver A. For Notebook computer: A. For PC computer: Insert the USB receiver into the USB port of your Notebook Insert the USB receiver into the USB port of desktop computer or computer. via a USB HUB. B. The USB receiver will automatically be recognized by your computer. C. Press the “connect” button on the USB receiver as shown, the Green Power LED will light up, and starts “Blinking”. D.
Power Management 1. To power on the mouse/keyboard, press the connect button on the bottom of the mouse once. 2. To turn off the mouse, press and hold the connect button on the bottom of the mouse until its optical light (RED) turns off. Note: Removing the batteries will require you to synchronize it with the receiver again the next time you turn it back on.
● System Requirements： ● Package Includes： To use the mouse/keyboard presenter, your computer must meet the following hardware requirements □ 2.4GHz RF Mouse and run one of the operating system listed below.
