User's Manual

Setting Up the Keyboard or Wireless Desktop

1. Make sure that your computer is turned off.

2. Connecting the Receiver’s Keyboard Cable:

(a) When connecting to an IBM AT keyboard port, use the 5-pin DIN

connector already attached to the keyboard cable.

(b) When connecting to a PS/2-style, 6-pin DIN keyboard port, remove

the AT adapter.

3. Place the receiver eight inches (20

centimeters) from any electromechanical

device.

Installing the Keyboard Software-

iKeyWorksOffice

Before you can take advantage of the many features

your keyboard offers, you must install the driver.

The driver is in the installation diskette that came

packaged with your mouse and keyboard

Windows 95/98/Me/2000/NT4.0 installation

Insert the installation diskette into your floppy disk drive.

Click the Start button and then click Run.

In the Run dialog window, type A:\setup, where “A” is the letter of your floppy disk drive.

Click OK and follow the instructions on your screen to complete the installation.

Selecting the Frequency Channel

The Wireless keyboard operates on two frequency channels..

Refer to the following to change the frequency channel for your

keyboard: Set the frequency channel on the receiver to 1 or 2. Set

the frequency channel on the keyboard to 1 or 2.

The Wireless keyboard ID code

Each keyboard is assigned a unique ID code at manufacture, so the receiver

only picks up the signal from your mouse and prevents other Wireless

keyboard radio signals from operating on your computer. This feature can

also be disabled, allowing other Wireless pointing devices to operate your

computer.