THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Federal Communications Commission Requirements The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules.
Getting Ready 1. ‘Tum off the power of your computer. w Remove the existing keyboard (and mouse for the AdTech® Wireless Desktop). 3. install the AA alkaline batteries in the Wireless keyboard. Remove the battery compartment cover on the bottom of the keyboard by squeezing the cover in from the tab to release it. 4.
Setting Up the Keyboard or Wireless Desktop 1. Make sure that your computer is turned off. 2. Connecting the Receiver’s Keyboard Cable: {a} When connecting to an TBM AT keyboard port, use the S-pin DIN connector already attached to the Keyboard cable. (b) When connecting to a 6-pin DIN keyboard part, remove the AT adapter. Connect the receiver's purple keyboard cable to the computer's keyboard port. 3.
In the Run dialog window, type A\setup, where “A” is the letter of your floppy disk drive. Click OK and follow the instructions on your screen to complete the installation. Selecting the Frequency Channel The Wireless keyboard and Mouse operates on two frequency channels. To prevent interference when using two RF Mice in close proximity a different frequency channel should be sed for each mouse.
Changing the Wireless Mouse ID Code You van use a new Wireless Mouse an your computer without changing the Radio receiver; you just need fo change the ID code. Refer to the following: 1. Press (Shift + Alt + F11] or [Shift + Alt + F12] to call up the Wireless Mouse ID Code window. 2. Move the Wireless Mouse for a few seconds to establish a connection, then click Connect ID. 3. The new [1 code is connected and the Wireless Mouse window closes. 4. Click Exit to close the Wireless Mouse 1D code window.
