Wireless Battery Free Optical Mouse User’ s Guide
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Federal Communications Commission Requirements Introduction Congratulations on your purchase. Your new Wireless BatteryFree Optical Mouse will offer you wireless freedom, yet no battery is required.
Press "TUNE" Button to obtain frequency for best performance.(First Time Use) 3. The working of frequency range is 0 to 50 centigrade degrees . How to TUNE 1. If your mouse is not on the mouse pad, the PWR LED light will be blinking. Place the mouse on the center of the mouse pad. The PWR LED light should now stop blinking and remain lit. 2. Press the “ TUNE” button 3. PWR LED turns “ Off” and the RUN LED light starts “ Blinking” . 4.
Power Pad Status List: LED Light Mode Red PWR LED“Blinking” Red PWR LED“On” Green RUN LED “Blinking” Green RUN LED “On” Red/Green LED “Off” Status Mouse is not on the mouse pad, or USB port power is low Mouse is on the mouse pad, and power is ready Press "Tune" Button in order to tune the Mouse Pad/Mouse Inductive Tuning to obtain the best signal reception. Mouse is active (moving, clicking on key, rolling wheel) Power is not being received by Mouse Pad.
NB- 35 ; NB-35A Spec. Manufacturer: A-FOUR TECH CO., LTD. Use of the equipment: For PC’ s Mouse E quipment category: Wireless Battery Free Optical Mouse Mode of operation: Simmplex Frequency / Frequency range: 121KHz ~ 128KHz Maximum transmitter output power: 2.5 mW Number of channels and channel separation: Scan frequency to lock a working point for Wireless Battery Free Mouse . Working frequency of E very Mouse maybe be different , working point from 121KHz to 128KHz.
