User Manual

Hardware Installation
1. Pull out the Nano-receiver from the bottom of mouse.
2. Plug Nano-receiver into USB port of your computer or
notebook.
3. Insert the supplied batteries, make sure that the positive (+) and negative (-) ends of the batteries match the
polarity indicators inside the batteries housing. Then the power will be automatically on. After wireless setup has
completed, the mouse is ready to use.
Power Management of the Mouse
1. To power on the mouse, press the power button for approximate 3 seconds.
2. To turn off the mouse power, press the power button on the bottom of the
mouse till the LED light is off.
Note: The mouse can be activated from sleeping mode easily by moving it
around.
The wireless mouse is plug-and-play. No driver is required. If you would like to get more function, please download software in our
website: www.a4tech.com
.
Mouse Button Identification
Software Installation
1. Before installing the mouse software, please uninstall any previously installed mouse software.
2.
Extract the ZIP file to your local disk and double click to start installation.
3. Follow on-screen instructions to complete the installation.
4. The icon
will appear on your desktop, then you have successfully installed the software.
5. To launch the software, double click the icon on your desktop or go to Start—Programs—A4tech 8-in-Right, then
the icon will appear in the taskbar at the right corner of your screen.
Software Instructions