Product specifications

AD-4329A Weighing Indicator Page 49
Set Zero band
Set the zero band value of the setpoint comparison. The decimal point is not
necessary because of according to display.
Templete S3, [ value ]
Command
Reply
12.1.7. Related Functions
F-Function Description
f-40 0
Displayed data
f-40 1
Gross data
f-40 2
Net data
f-40 3
Tare value
Output Data
f-40 4
Gross data / Net data / Tare value
Output mode
F-Function Description
Stream mode
f-41 0
Description of "Stream Mode" at page 31
Auto print mode
f-40 1
Description of "Auto Print Mode" at page 31
Manual print mode
f-40 2
When pressing the PRINT key each time, the data is output once.
Command mode
(no address)
f-40 3
Command mode
with address
f-40 4
Refer to "12.1.3.Command Format" of RS-232C interface.
Auto-print condition
F-Function Description
Positive data only
f-42 0
"Inhibition region of output" +5d.
+5d < "permission region of output".
Positive and
negative data
f-42 1
-5d "inhibition region of output" +5d.
"Permission region of output" < -5d, +5d < "permission region of output".
F-Function Description
f-43 0
Not used Delay for continual
data
f-43 1
Approximately 2 seconds
Baud rate
f-44
600 bps, 1200 bps, 2400 bps, 4800 bps, 9600 bps
Data format
f-45
Refer to "12.1.2.Data Format" of RS-232C interface.
f-46
Address
00 to
99
Factory setting is 00.
When f-41 4 is not selected, f-46 is ineffective.
CF-Function Description
Cf-07 Data output of tare
Cf-08 Output on over load and unstable state. Use or not used
Cf-09 Format of Header Selection of TR, PT, GS, NT, T, G and N
Cf-10 Figure number of unit, decimal point Two figures or three figures, dot or comma
Cf-11 Accumulation function Effective or ineffective
12. RS-232C Interface