Product specifications

Page 26 AD-4329A Weighing Indicator
6. Functions
There are two parameters list for the F-functions and CF-functions. These functions
control the indicator. The parameters of each function are stored in the EEPROM, and
are not lost even if the AC power supply is disconnected.
F-functions: These parameters can always be changed and are used for
internal settings.
CF-functions: If you accept a certificated approval of the weighing instruments,
the CAL cover must be sealed. Therfore, accepting this approval,
these parameters of the CF-function can not be changed.
6.1. Changing the Function Settings
Step 1 Press the Operate/Standby key to turn the display off.
Step 2 Press and hold the MODE key and press the
Operate/Standby key. The f-00 is displayed.
Operating Item
Step 3 Select an item using the following keys.
key..... The key to select a figure.
key..... The key to select a number.
key..... The key to display a parameter of
the selected item.
Proceed to step 4.
CAL key .. The key to exchange F-functions
and CF-functions.
Operating parameter
Step 4 Select a parameter using the following keys.
key..... The key to select a figure or a switch
(at f-06 and f-46).
key..... The key to select a value (or condition
at f-06 ).
key..... The key to store a parameter and
proceed to step 3. (all switch stored at
f-06)
MODE key. The key not to change the parameter. Proceed to step 3.
Step 5 Press the Operate/Standby key to exit the mode. Then display turns off.
6. Functions