Instruction manual

English 10
Step 2
[
Select The C.P.G. or my C.P.G.]
The C.P.G. function My C.P.G.
button
Ex.: user 1
START button and to "8. Measurement"
6. The C.P.G. Function Switch
Refer to page 16 for the C.P.G. function that will indicate the proper
angle so that the height of the cuff is the same level as your heart.
1. After step 6 in page 8, press the
button to select either " " or
"
" concerning the C.P.G. function.
2. Press the
SET
button to store the selection.
3. If you do not use my C.P.G. function, press
START
button
to turn off. Proceed to "8. Measurement".
If you use my C.P.G. function, proceed to "7. Selecting the
C.P.G. and my C.P.G.".
7. Selecting the C.P.G. and my C.P.G.
You can select an indicator either the C.P.G. function or my C.P.G. .
Preset a proper posture (wrist angle) in memory if you use the my C.P.G. .
1. Adjust and keep the height of the blood pressure monitor to
the same level as your heart using your wrist angle.
2. Select an indicator using the
button.
Indicator
.....
The C.P.G. function is used. (my C.P.G. function : OFF )
Data of my C.P.G. is deleted. Proceed to step 3.
Indicator
.....my C.P.G. function is ON and the current angle is stored
when switched to the indicator
. Proceed to step 3.
3. Press the
START
button to turn off the device.
From step 6 of page 8
The C.P.G. function
button
Press the
SET button
To "7. Selecting the C.P.G. and my C.P.G." or
START button and to "8. Measurement"
Step 1 [Adjust and keep the height
of the device (wrist angle) ]
HIGH
(Orange light)
Correct Height (Blue light)
LOW
(Orange light)
The C.P.G. indicator