Instruction manual

English 7
Operation Mode
1. Normal Measurement
Press the START button. Blood pressure is measured and the data is stored in memory. This device can store the
last 90 measurements in memory.
2. Recalling the Memory Data
Measurements stored in memory are assigned an index number in the order of
the newest to the oldest. The oldest reading displays as “n01”.
1. Press the
MEMORY button. You will see the average blood pressure displayed.
2. Press the
MEMORY button again. You will see the index number of the
most recent reading followed by the measurement data.
3. If the
MEMORY button is pressed again, the UB-351 will display the data
starting with the chronologically recent data in memory.
4. If you want to retrieve other measurements in memory, press and release
the
MEMORY button repeatedly until the desired index number is reached
(e.g. n14). The measurement will then be displayed.
Notes: The device will turn off automatically after the index number and results are displayed twice.
If there are no measurements stored in memory, the display indicates dashes as
shown to the right.
3. Deleting all Data Stored in Memory
To delete all data stored in memory, remove the batteries from the battery compartment.
4. For Those Whose Systolic Pressure is Over 150 mmHg
Refer to page 11 for measurement with the desired systolic pressure.