Instruction manual

English 5

Operation Mode

1. Normal Measurement With Storing Data

Press the START button. Blood pressure is measured and data is stored

within the device. The device can store the last 90 sets of data in memory.

2. Recalling The Data

Press the MEMORY button to recall the data.

The average data of all the measurements

is displayed, as indicated in the figure at

the right.

Then, each time the

MEMORY button is

pressed, the memory data is displayed

from the most recent.

For details on recalling data, refer to

“Recalling Memory Data”.

The device can store the last 90 sets of

data in memory.

3. Clearing The Data

Press and hold the MEMORY button until the “ ” (memory) mark blinks to

clear the stored data.

4. Measurement With The Desired Systolic Pressure

Refer to page 11 for measurement with the desired systolic pressure.

5. Switching The Unit Of Temperature

In the clock setting mode, when the dashes in

the temperature displaying area are blinking,

press the

PM button to select °C or °F. Then,

press the AM button or START button to

return to the clock display.

For details on the clock setting mode, refer to

“Adjusting The Built-in Clock” on page 7.

Select the unit

of temperature

verage of

all the data

Averaged systolic

Averaged diastolic

Number of data

Press

Most recent data:

Displays alternately

every 3 seconds