Instruction manual

English 11
Measurements
Model UA-852 is designed to detect the pulse and to inflate the cuff to a
systolic pressure level automatically.
If your systolic pressure is expected to exceed 230 mmHg or you use the optional
small cuff, read "Measurement With The Desired Systolic Pressure" on the next page.
Normal Measurement
1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2. Press the START button.
0 (zero) is displayed blinking briefly. Then
the display changes, as indicated in the figure
at the right, as the measurement begins. The
cuff starts to inflate. It is normal for the cuff to
feel very tight.
A pressure bar indicator is displayed, as in
the figure at the right, during inflation.
Note: If you wish to stop inflation at any time,
press the
START button again.
3. When inflation is complete, deflation starts
automatically and
(heart mark) blinks,
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
4. When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
5. Press the START button again to turn off the power.
Note: Model UA-852 is provided with an automatic power shut-off function.
The clock display remains on the LCD. Allow at least ten minutes
between measurements on the same person.
At heart level
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
Exhausts remaining
air automatically
Press
Zero display
START