Instruction manual

11
About Memory
The device automatically stores up to ninety blood pressure and pulse
measurements in memory. Data stored in memory are assigned a data number
in the order of the newest to the oldest. The oldest data displays as "n01". The M
symbol in the lower left corner of the display indicates that you are viewing
previous data stored in memory.
Recalling Data
1. When nothing is displayed, press the MEMORY button.
The data number of the most recent measurement and the
data are displayed.
2. If you want to see the previous data, press the
MEMORY button until getting the data you want.
3. The display will shut off automatically one minute after you
press the
MEMORY button.
Note: If press the START button when recalling data,
the display shuts off.
Clearing Data
To clear all data stored in memory:
Press and hold the MEMORY button until the
“M”(memory) mark blinks three times.
Remove the batteries and press the START or
the MEMORY button.
Re-install them again.
If there is no stored data in the memory, "--" will appear.
Pres
s
Press and hold