Instruction manual

English 9
Preparation for Measurements
5. Applying the Arm Cuff
1. Wrap the cuff around the upper arm,
about 1-2 cm above the inside of the
elbow, as shown.
Place the cuff directly against the skin,
as clothing may cause a faint pulse, and
result in a measurement error.
2. Constriction of the upper arm, caused
by tightly rolling up a shirtsleeve, may
prevent accurate readings.
3. Confirm that the index
points within
the proper fit range.
6. How to Take Proper Measurements
For the most accurate blood pressure measurement:
Sit comfortably on a chair. Rest your arm on the table. Do not cross your
legs. Keep your feet on the floor and straighten your back.
Relax for about five to ten minutes before measurement.
Place the center of the cuff at the same level as your heart.
Remain still and keep quiet during measurement.
Do not measure immediately after physical exercise or a bath. Rest for
twenty or thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.
7. Measurement
During the measurement, the cuff will become very tight. Do not be alarmed
as this is normal.
8. After the Measurement
After the measurement, remove the cuff and record your data.
Note: Allow at least three minutes between measurements on the same
person.
Do not roll up shirtsleeve tightl
y
1 to 2 cm
A
ir hose
Cuff
Inde
x
and Proper fit range
A
rtery position mark
Secure the fabric
fastener firmly