Instruction manual

English 13
Measurements
Measurement with the Desired Systolic Pressure
Model UA-767NFC is designed to detect the pulse and to inflate the cuff to a
systolic pressure level automatically.
Use this method when re-inflation occurs repeatedly
or when the results are not displayed even if the
pressure decreases to 20 mmHg or less.
When the memory setting is 0:
1. Place the cuff on the arm (preferably the left arm).
2. Press and hold the START button until a
number about 30 to 40 mmHg higher than
your expected systolic pressure appears.
3. When the desired number is reached, release
the
START button to start measurement.
Continue to measure your blood pressure as
described on the previous page.
When the memory setting is 100:
1. Place the cuff on the arm (preferably the left arm).
2. Press the START button.
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
3. Press and hold the START button
until a number about 30 to 40 mmHg
higher than your expected systolic
pressure appears.
4. When the desired number is reached,
release the
START button to start
measurement. Continue to measure
your blood pressure as described on
the previous page.
Refer to the previous
page for measurement
Press and hold
the button
At heart level
Release the button
at the desired
systolic pressure
START
START
START
Refer to the previous page
for measurement
Press and hold
the button
At heart level
Release the button
at the desired
systolic pressure
Press
Zero blinking
A
ll of the displa
y
segments displaye
d