Instruction manual

18
Continued
SpO
2
value
•Updates the value during measurement.
•Displays " - - - " during pulse detection, and "LF"
when the sensor is not connected.
SpO
2
value
(When an alarm occurs)
•Flashes in red when the limit values are exceeded.
•Retained until the value is within the limit values.
"%"
•Displayed as the unit of SpO
2
.
5 SpO
2
display
"" (Red circle)
•Displays a red circle near "SpO
2
" when the limit
values are set.
6
ECG waveform
display
ECG waveform
•Displays the ECG waveform in the preset sweep
rate.
•Not available for TM-2560G/TM-2560GP.
7
Plethysmograph
display
Plethysmograph
•Displays the SpO
2
plethysmograph in the preset
ECG sweep rate.
•Two displays for TM-2560G/TM-2560GP. (The
sweep rate is fixed to 25 mm/s.)
8 Patient display
Patient to measure
blood pressure
•Displays "ADULT" to indicate that the patient whose
blood pressure to be measured is adult.
Interval to measure
blood pressure
•Displays the preset blood pressure measuring
interval.
9
Measuring
interval display
"CYCLE"
•Displayed to indicate that the blood pressure
measuring interval is displayed.
10
Measuring time
display
Blood pressure
measuring time
•Displays the time the blood pressure is measured.
11
Blood pressure
unit display
Blood pressure unit
•Displays "mmHg" as the unit of blood pressure.
12 Error message
Blood pressure
measurement error
•Displays the error that occurs during blood
pressure measurement.
13
ECG lead
display
ECG lead
•Displays the preset lead type as "l", "ll", or "lll".
14
ECG displaying
magnification
display
ECG displaying
magnification
•Displays the preset ECG displaying magnification.
15 Alarm off mark Alarm off mark
•Illuminates when the ALARM OFF key is pressed to
stop the alarm.
16
Current time
display
Current time
•Displays the current time.
17
Power supply
display
Power supply
•Displays the power currently used.
•Displays the remaining battery charge when the
battery is used. (Refer to "6-12 Power Supply".)
Temperature probe ID
•Displays the preset temperature probe ID as "T-∗∗".
Temperature value
•Updates during measurement using the
temperature probe.
•Displays " - - - " when communication with the
probe is disconnected.
Antenna mark
•Displays the communication status by the number
of antennas.
Temperature value
(When an alarm occurs)
•Flashes in red when the limit values are exceeded.
•Retained until the value is within the limit values.
"°C "
•Displayed as the unit of temperature.
18
Temperature
display
"" (Red circle)
•Displays a red circle near temperature probe
display when the limit values are set.