Instruction manual

Page 5
Notes on the Blood Pressure Recorder
Storage
Do not store the recorder in the following places.
Where the recorder could be splashed with water or other liquids. If the
recorder becomes soaked, it needs a repair. (Do not use the recorder.)
Where the temperature and humidity are high, or in direct sunlight.
Where the recorder may be influenced by vibration or shock.
Where there is dust, salt or sulfur vapor.
Where chemicals are stored, or chemicals are evaporating.
Before use
Cover the RS-232C terminal using the cap, to avoid dust.
Confirm that the recorder works correctly and measurement values are proper.
Confirm that the cuff and air hose are connected properly.
Confirm parts in direct contact with the patient. Keep these parts clean.
Use a clean cuff cover. Because it comes into direct contact with the patient.
Delete the old data before starting a new measurement.
Avoid strong magnetic field and static electricity.
Do not use this recorder while using high frequency surgical equipment.
During use
The recorder should be operated by medical personnel who knows it well.
Use the recorder only during the time of diagnosis or medical treatment.
Stop using the recorder, if the patient feels pain in the arm or the recorder does not
measure properly.
The measurement cycle may be reduced due to the environment.
When an inside part of the recorder becomes soaked (wet), turn off the power
switch and request service from your supplier or the A&D service group.
After use
Clean the recorder, cuff and accessories for the next use. Do not pull or kink hoses.
Do not use organic solvent, antiseptic solution, etc.
Turn off the power switch after measurement.
Please use the original box for transportation.
Periodic maintenance
The recorder is a precision instrument. Please check all functions periodically
(every year). Contact your nearest A&D dealer for the inspection.
Environmental protection
If you discard the recorder, remove the Ni-MH batteries and built-in Li battery from
the recorder.
Dispose of the Ni-MH batteries in the designated container for recycling.
Dispose of the Li battery properly as a hazardous waste.