Instruction manual

Page 20
Mode III Settings
Setup procedure
Before you enter into mode III, read the procedure below. Also, refer to the
example on the next page for the setting procedure.
Each block’s finish time is the next block’s start time.
The end of block 6 automatically becomes the start time of block 1.
If you enter the block 1 start time in any other block, these parameters are
saved and this sequence is finished.
When selecting 120 minutes for the current frequency, you must adjust the
start time of the next block so that the current block fits a multiple of 120
minutes. If not, an error code is displayed.
The recorder displays as 60 minutes and as 120 minutes.
When you enter the sequence of mode III settings, the recorder initializes each start
time to the start time of block 1 and each frequency to "-" (not used).
To read the current settings, press the START STOP key in this sequence.
Display & key
Items
Sequence
number
Parameters (monitor) Meaning Initial value
01 0 ~ 23 o'clock Start time of first block
02 - , 5, 10, 15, 20, 30, 60, 120 minutes Frequency of first block
03 0 ~ 23 o'clock Start time of second block
04 - , 5, 10, 15, 20, 30, 60, 120 minutes Frequency of second block
05 0 ~ 23 o'clock Start time of third block
06 - , 5, 10, 15, 20, 30, 60, 120 minutes Frequency of third block
07 0 ~ 23 o'clock Start time of fourth block
08 - , 5, 10, 15, 20, 30, 60, 120 minutes Frequency of fourth block
09 0 ~ 23 o'clock Start time of fifth block
10 - , 5, 10, 15, 20, 30, 60, 120 minutes Frequency of fifth block
11 0 ~ 23 o'clock Start time of sixth block
12 - , 5, 10, 15, 20, 30, 60, 120 minutes Frequency of sixth block
13 0 ~ 23 o'clock End of sixth block
"-" means "not used".
AUTO
ON/OFF
START
STOP
Sequence number
Parameter
Sign of setting parameters
for automatic measurement
Selecting a
parameter
Selecting a sequence number