Instruction manual

Page 15

Step 8 Attach the cuff to the patient. Refer to "Attaching the Cuff

and Recorder".

Step 9 Attach the carrying case to the patient and insert the recorder.

Refer to "Attaching the Cuff and Recorder".

Step10 Check the recorder using the manual measurement with

relaxed, but correct posture. Refer to "Manual Measurement".

Step11 Start the automatic measurement. The recorder displays

"A" and starts the automatic measurement sequence.

Refer to "Automatic Measurement".

Step12 When using automatic measurement, consider the following.

Consider the sections "Patient instructions" and "Notes

on the Blood Pressure Recorder".

When the patient uses mode II of automatic

measurement, press the AUTO ON/OFF key with each

rising and going to bed.

Step13 When the automatic measurement sequence is finished,

the "A" sign turns off. Refer to "Automatic Measurement".

Step14 Remove the cuff and recorder from the patient.

Step15 Transfer the patient’s data and save it in other media.

Refer to "Data transfer".

Step16 Clean the cuff and recorder and place them in storage.

Refer to "Before use" and "Maintenance".

Step 8

Step 9

End

Step 10

Step 11

Step 16

Step 12

Step 13

Step 14

Step 15