Instruction manual

Page 14

The complete procedure for use

Step by Step Procedure

Step 1 Battery replacement.

Replace with new alkaline batteries (note direction).

Refer to "Replacing the Batteries" on page 16.

Step 2 Turn on the recorder using the power switch.

Step 3 Follow the procedure, depending on the recorder state.

Case 1 Normal state

The buzzer sounds once and the clock is displayed. The

recorder is ready for use. The recorder stores parameters

for "display and clock" and "automatic measurement".

Please proceed to Step 5.

Case 2 Error state

When the recorder displays the error code, it is necessary

to set parameters for "display and clock" and "automatic

measurement". Please proceed to the next step.

Step 4 Set parameters for "display and clock". When you use

automatic measurement, set parameters for automatic

measurement. Refer to "Parameters for the Display and

Clock" and "Selection for the Automatic Measurement".

Please proceed to Step 6.

Step 5 Set new parameters for "display and clock" and "automatic

measurement", if necessary.

Step 6 Delete the old data stored in the recorder. Refer to "Deleting

Old Data".

Step 7 Explain "Patient Instructions" and " Notes on the Blood

Pressure Recorder "to the patient.

Step 1

Step 2

Step 3

Case 1

Normal

Case 2

Error

Step 4

Step 5

Step 6

Step 7