User manual

A&D Board User Manual and Test Procedure

Completion

1. [ ] Unplug the power supply module from the 120V AC outlet and then the DIN5 connector from the

breadboard.

2. [ ] Write a detailed description of any test that does not meet specifications in the comment block below.

3. [ ] If you had difficulty with any of the test procedures, or discovered errors, please comment below and

communicate this information to your instructor.

4. [ ] For help with A&D Board service, follow the instructions on the CEL web page for your class.

Comments:

I have performed the above procedure and, excluding the exceptions noted above, I am satisfied the A&D board is

working properly.

Signature:________________________________________________________

Date:______________________________