User manual

A&D Board User Manual and Test Procedure

Oscilloscope Operation

Figure 2: TDS210 Oscilloscope Front Panel

1. [ ] Turn on the TDS210 oscilloscope. The power button is top left.

2. [ ] Connect a BNC-to-mini-grabber cable to the CH 1 BNC connector of the TDS210 oscilloscope.

3. [ ] Connect the red mini-grabber end to the TDS210 PROBE COMP ~ 5V

_⎡⎤_ (upper connector).

4. [ ] Press the CH 2 Menu button until the CH 2 indicators disappear from the bottom of the screen.

5. [ ] Press the CH 1 Menu button until the CH 1 waveform appears on the TDS210 screen.

6. [ ] Use the buttons just to the right of the TDS210 screen to set CH 1: Coupling=DC, BW Limit=OFF,

Volts/Div=Coarse, Probe=1X, Invert =OFF.

7. [ ] Press AUTOSET

8. [ ] Verify the waveform looks very similar to Figure 3.

Figure 3: Oscilloscope Display of Probe Comp ~ 5V

_⎡⎤_

The TDS210 Oscilloscope manual can be found at http://www.ece.vt.edu/cel/help/TDS210-User-Manual.pdf