Specifications

Tap the UNITS switch

to select an item

and

Tap the TARE switch

to execute it.

To exit from the calibration mode,

touch

the switch or Press the CAL

switch. The scale turns the power OFF.

10.2. Gravity Acceleration Correction

When the scale is first used or has been moved to another location, it should be calibrated

using a calibration weight. But if a calibration weight is not available, the gravity

acceleration correction will compensate the scale. Change the gravity acceleration value

stored in the scale to the value of the area where the scale will be used. Refer to the

gravity acceleration map at the end of this manual.

Note: Gravity acceleration correction is not required when the scale will be

calibrated using a calibration weight at the place where it is to be used.

1. Refer to "10.1. Calibration Mode" to enter the calibration

mode. The gravity acceleration value is displayed.

Tap the TARE switch to enter the gravity acceleration

value setting mode.

3. Change the displayed value using the following switches.

UNITS To shift the blinking digit to the right.

SAMPLE To increase the value of the blinking digit by one.

4. Tap the TARE switch. The display shows and

returns to the newly stored gravity acceleration value.

5. When calibration using a calibration weight is to be performed,

go to step 3 of "

10.3. Calibration Using A Weight".

To finish the setting procedure,

touch the switch

or the CAL switch. The scale returns to the weighing mode.

Weighing mode

Power OFF

Gravity acceleration

correction

Calibration using

a weight

Restoring the factory

set values

Method 1

Touch & hold

Calibration mode

Method 2

Press

Tap