Setup guide

8-6
EPC Connecting Guide
Quick Installation Guide
Audience: The following provides quick procedures for installing the SuperStack
II Switch
9300. It is intended for trained technical personnel only who has experience installing
communications equipment.
To install the SuperStack
II 9300 switch, follow the steps in this section. If you need more
information on each setup task, see the related sections in this guide or complete details in
the indicated documents.
Determine Site Requirements:
Install the SuperStack II Switch 9300 system in an area that meets the requirements in
Figure 44.
Figure 44. System Site Requirements
Location
· Ambient (room) temperature – 0 to 50 C (32 to 122
· Relative humidity – 10% to 90%, noncondensing
· A level surface for system installation
Power · Power supply – 175 Watts
· Power source location –
AC or DC power source within approximately 1.8
meters
· Input voltage options – 100 to 120 VAC or 200 to 240 VAC
· Current rating – 100 VAC at 1.9 amperes (maximum) or 200 VAC at 0.79
amperes (maximum)
Warning: For your safety and to ensure adequate cooling airflow, keep blank faceplates
over all empty slots.
If you need more information on site requirements, see Appendix B: Site Requirements and
Safety Codes in the Getting Started Guide for your system
Unpack the system
Check the packing slip to ensure that you have all of the components that you ordered.
The system is shipped with one power supply installed. If you have ordered a redundant
power supply or uninterruptible power supply for the system, be sure to have it available for
installation.
Install the system
Before you install the system:
• Move the system close to where you plan to install it.
• Have a Number 1 Phillips screwdriver available.
• Have the hardware kit available. See below
Figure 45. System Hardware Mounting Kit
Item
Qty Use in
Rubber feet (self–adhesive) 4 Installing the system on a table top
Mounting bracket 2 Installing the system in the distribution rack
M4 x 10 Phillips pan–head screws 6 Installing the system in the distribution rack
Determine whether you are installing the system on a tabletop or in a distribution rack.
For complete installation instructions, see Chapter 2: Installing the System in the Getting
Started Guide for your system.