Setup guide

6-29Console Cabling Requirements
Cabling Diagrams for a 2–node Configuration
There are two CBLG105–1800 cables . A first one is generated automatically and
systematically in any Escala EPC order. The second one is included in the Cluster Console
component.
For connecting the nodes to the cluster hub, please use the native integrated Ethernet
board.
Temporary Replacement of a Cluster Console with a System Console
The Cluster Console acts both as system console and administration graphical console. The
delivered System Console is not wired. It is used as spare console. If the Cluster Console is
out of order, the System Console (a BQ306 ASCII terminal) can be connected to the S1 port
on node #1.
Note: If the node is an EPC1200 or an EPC1200A, it may be necessary to add a CBL2101
cable to the CBLG105-1800 cable  when connecting the X terminal to the node’s
S1 serial port. This is the case when the X terminal has not been initialized before
the connection.
Figure 20. PWCCF02: Temporary Replacement of Cluster Console with System Console