Setup guide

10-34
EPC Connecting Guide
Cabling for Configuration & Management
EPC800, EPC1200 EPC1200A, EPC2400, EOC430 and EPC440 Nodes
The following cabling configuration requires a serial multi-port asynchronous card.
Connect the RS232 cable to a port left on the multiple ways asynchronous boards of a node
that shares the DAS.
For a single DAS with one SP, connect the DAS to the first node, as shown.
Figure 87. Cabling for Configuration & Management, 1 DAS, 1 SP.
For a single DAS with two SP, connect a first serial cable from the console plug of SP–A to a
node, then connect a second cable from the console plug of SP–B to another node.
Figure 88. Cabling for Configuration & Management, 1 DAS, 2 SP.
With 2 DAS cabinets, distribute fairly the cabling between the nodes sharing the DAS.