Quick start manual

Page 9
6500 Configuration Using Viewer
Configuration of the 6500 can be performed using the
Ranger 6500 Viewer software for Microsoft Windows.
The 6500 must be connected to the PC using the
secondary RS232 port located behind the units plate.
Wiring requirements for the cable are given below. The
secondary serial port must be configured as a Network
Slave, however this is the default operation of this port.
The Viewer software provides a simulation of the display
and allows remote operation of the keys from the PC.
Configuration settings of the 6500 can be written to and
read from the display. In addition, settings can be altered
as necessary and may also be written to file.
Viewer Cable
Ranger 6500
Secondary RS232
P
C
235235