Specifications

58
(4) Measuring the density of a liquid ( Specific gravity ) (d5 1)
Note
The density display is four decimal places. The minimum display can not be changed with
the SAMPLE key.
The density (or specific gravity) is displayed after "Mass measurement of a
float in air" and "Mass measurement a float in liquid". The procedure of each
measurements is as follows: g : gram.
: the processing indicator.
1 Enter the density mode. (g lights.
blinks.)
Place nothing on the weighing pan and press the
RE-ZERO key to display zero.
2 Place the float on the weighing pan. (g lights. blinks.)
If the weight value of the float is output, press the PRINT
key to store it after a stable weight value is displayed.
Press the SAMPLE key to decide the weight value in air
and proceed to next step.
Note
If negative value or e (out of range) is
displayed, the SAMPLE key is inactive.
3 Pour in the liquid for the density measurement and
submerge the float in the liquid. At this time, confirm that
the float is approx. 10 mm under the liquid surface. Wait
until the display is in the stable state to take a reading.
If the weight value is output, press the
PRINT key.
Press the SAMPLE key to decide the weight value in
liquid and proceed to next step.
Note
If e (out of range) is displayed, SAMPLE key
is inactive.
4 Inputting the volume of the float
Refer to "Entering the volume of a float" and Input the
volume of a float. Press the
SAMPLE key to proceed to
the next step.
5 If the density value is output, press the
PRINT key to store it.
(Unit : . g turns off. lights.)
Press the SAMPLE key to measure another sample and
proceed to step 2.
6 Press the the
MODE key to proceed to other modes.
From "Entering the
density of a liquid"
Place the floa
t
on
the weighing
pan.
S
ubmerg
e
the float
in the liquid.
Remove floa
t
Outpu
t
Outpu
t
Outpu
t
Weighing in air.
g lights.
blinks.
Weighing in air.
g lights.
blinks.
Weighing in liquid.
g lights.
lights.
Density display.
g turns off.
lights.
Volume input
t
in
g
.
g turns off.
lights.