Specifications
Table Of Contents
- Overview
- Configuration
- Configuration Profiles
- General Profile Settings
- Configuring Devices
- Activating Tag Actions
- Validation Constraints
- Audible Alert Sound Events
- Data Collection and Validation
- Importing and Exporting
- Tools
- Tag Actions
- Tag Action Manager
- Tag Action Settings and Commands
- Tip: the Replace command will import tag codes much faster than the Import command. Use the Import command only when appending a relatively small number of tag codes (less than 25k) to a tag action.
- Tip: the Delete All and Replace commands will generate a lot of empty space in the P3 database. We recommend running the Compact and Repair utility after running any of these commands to optimize the database.
- Tag Actions and Data Entry
- Digitizer Maps
- Searching Data
- Replacing Data Values
- Merging Tag Sessions
- Dot-Out Wizard
- Remove Dot-Outs
- Duplicate Viewer
- Validation Codes
- Database Maintenance
- Tag Actions
- Appendix
- Frequently Asked Questions
- Hardware Support
- Troubleshooting Common Tag Reader Problems
- Troubleshooting Common Digitizer Tablets Problems
- Digitizer Tablet Doesn't Register Pen Clicks
- WinTab Digitizer Tablet Won't Communicate with a PC
- ASCII Digitizer Tablet Won't Communicate with a PC via Serial Port
- Digitizer Tablet doesn't Communicate with P3
- Digitizer Tablet is Sending the Wrong Commands
- Digitizer Tablet is Sending Wrong Lengths
- Digitizer Tablet Hangs P3 when Connected via Baytech Multiport
- Operating the Destron 400 kHz Benchtop Tag Reader
- Configuring Calcomp Drawing Board III
- Index
P3 Help
8
Note: Changing the active profile while a Tag Session is open will cause peripheral
devices to be disconnected and reconnected to the application; it may also reset the
default repeating comments.
Tip: Clicking on the Active Profile label on the toolbar will automatically open the
active profile for editing.
Profile Settings
Profile settings control how a tag session
will collect and display data. Only after
pressing the OK or Apply buttons on the dialog box will changes to the profile
settings be saved. If changes are made to the active profile and a tag session is
currently open, the new settings will take effect immediately. However, take care in
doing this; as with changing the active profile, this too will cause devices to
disconnect and reconnect to the application and it's possible to miss a scanned tag
code during this very short period of time.