Specifications

7-4 Calibration Test Using an External Weight

This function tests the balance weighing accuracy using an external weight and outputs the result. This

is available only when the “GLP output (info)” parameter is set to “1” or “2”. (Calibration test does not

perform calibration.)

Operation

1 Connect the AC adapter and warm up the balance

for at least 30 minutes with nothing on the pan.

2 Press and hold the

CAL key until CCout is

displayed, and then release the key.

3 The balance displays CC 0 .

If you want to change the target weight (a list of

usable weights is shown on page 28), press the

SAMPLE key and proceed to step 4.

If you use the target weight value stored in the

balance, proceed to step 5.

4 Specify the target weight value as follows:

SAMPLE key To switch the display condition to:

“All of the segments blinking”

(target weight selection mode) or

“The last two digits blinking”

(value adjustment mode).

RE-ZERO key (To increase the value)

MODE key (To decrease the value)

To select the target weight or

adjust the value.

PRINT key To store the new weight value.

Even if the AC adapter is

removed, the data is maintained

in non-volatile memory.

CAL key To cancel the operation and

return to CC 0 .