Instruction manual

9
2-2 Installing the Balance
Install the balance as follows:
1. Place the balance on a solid weighing table. Refer to “3. PRECAUTIONS” for installing the balance.
2. FZ-GD series (all models) and
FX-120GD /200GD /300GD
Assemble the pan support, weighing pan and small breeze break, on the balance as shown in
the illustration on page 7.
FX-1200GD /2000GD /3000GD
Assemble the pan support and weighing pan on the balance as shown in the illustration on page 7.
FZ-300CT /600CT and FX-300CT /600CT
Assemble the breeze ring, pan support, weighing pan and large breeze break on the balance as
shown in the illustration on page 8.
3. Adjust the leveling feet to level the balance. Confirm it using the bubble spirit level.
4. Confirm that the AC adapter type is correct for the local voltage and power receptacle type.
5. Connect the AC adapter to the balance. Warm up the balance for at least 30 minutes with
nothing on the weighing pan.
Note
The AC adapter plug is protected against dust and may be difficult to insert. When inserting
the plug, turn the plug while pushing on it.