Specifications

ADF-3200 Installation and Operation Guide
Date : July. 1st. 2013
- 9 -
- 3D filter : separator left and right images from each other
- Panel drive cable : connecting between side of body and 3D-filter
- Right moving button : for moving 3d-filter to the right
- Left moving button : for moving 3-filter to the left
- Panel drive signal out : connecting one side of panel drive cable
- L/R mode change button : left & right image switch button
If the 3D image sequences are diverted, press this L/R mode change
button. It enables the conversion of L and R images sequences
- 3D sync in : connecting 3D sync cable from 3D port of projector
- RGB(D-Sub) image in : connecting D-Sub cable from RGB out of projector
- Remote control receiver in : connecting receiver cable from remote controller
- 3D indicator LED : 3D mode indicator
When the 3D images or sync is properly connected, green LED turns on
- Power LED : When system is powered, red LED turns on
- Power(DV 24V) : connecting DC jack from adaptor