Instruction manual

9-4
Display Check Item
“Chc Out”
Control output (Terminal #10 to #19)
Turns on a terminal #10 to #19 in this order and displays a relevant terminal-number as shown below.
(This check is performed automatically.)
* Ignore these displays, “J11 6” , “J11 4” , “J11 2” . They are for factory use.
* To return to the check item-selecting mode, press [ESC].
Terminal # Display
10
“tb1-10 1”
11
“tb1-11 2”
14
“tb1-14 3”
15
“tb1-15 4”
18
“tb1-18 5”
19
“tb1-19 6”
“Chc rS”
RS-232C/422/485
 Pressing [ENTER] sends 123<CR><LF>(ASCII code) at the condition configured in its function,
rSF-03, rSF-04, rSF-05, or rSF-06 and checks if the same data is returned.
An installed option name is displayed on the sub display. In case of OP-03 (RS-422/485), press
[F] to see either “485” or “422” setting.
* To return to the check item-selecting mode, press [ESC].
Result of check Display
Good condition
“PASS”
Something wrong No change on display
“Chc An”
Analog output
Apply a current in the range of 2mA to 22mA with [FUNC.] (Increase) and [F] (Decrease) and see if the
current value is displayed.
* To return to the check item-selecting mode, press [ESC].
9-2 Clearing “Zero” and “Tare”
To clear the Zero and Tare stored in the memory, turn on the power while pressing [TARE].