Instruction manual

9-3
Display Check Item
“Chc LEd”
LEDs
 Pressing [F] or [ENTER] shows a relevant number of the LED as “no.XX” and illuminates the
LED.
* To return to the check item-selecting mode, press [ESC].
LED Display
SET POINT
“no. 1”
TOTAL
“no. 2”
ACCEPT
“no. 3”
OVER
“no. 4”
UNDER
“no. 5”
“Chc buZ”
Buzzer
 Pressing [ENTER] sounds the built-in buzzer and displays “buSy” while sounding.
* To return to the check item-selecting mode, press [ESC].
* If the buzzer has sounded continuously for 10 minutes, it returns to the check item-selecting mode
automatically.
“Chc EEP”
EEPROM
 Pressing [ENTER] checks the function of the EEPROM and displays “buSy” while checking.
The results of the check will be displayed later.
* The keys will not work while checking the EEPROM.
* To return to the check item-selecting mode, press [ESC].
Result of check Display
Good condition
“PASS”
Something wrong
“Err”
“Chc bAt”
Lithium battery
 Pressing [ENTER] checks the function of the battery. The results of the check will be displayed
later.
Result of check Display
Good condition
“PASS”
Something wrong
“Err”
“Chc Si”
Standard serial output
 Pressing [ENTER] tests the function of the standard serial output by sending
123<CR><LF>(ASCII code) at the baud rate set in the SiF-03 function setting.
“Send123” is
displayed for one second and it returns to the check item-selecting mode.
* To return to the check item-selecting mode, press [ESC].
“Chc in”
Control input (Terminal #1 to #6)
Displays the status of the control input terminals, #1 to #6, on the control signal terminals, located
inside the case. “□” at an ON terminal is displayed at the lower position, an OFF terminal at the up
position.
* To return to the check item-selecting mode, press [ESC].
Example: Terminal # 1,3,4,5: ON, and #2, 6: OFF