Instruction manual

8-15
*
See {8-6 Data Transmitting Format —Data Format} for “Data Format”.
*
See {8-7 Command Mode— Communication procedure} for “Procedure”.
Command Command name Function Procedure
Data
Format
HB (Halt Batch) Halt batch in an emergency A
• This command is available only in the built-in automatic program mode weighing.
• In other weighing mode, "IE" will be transmitted.
RF (Request Final) Recalls the final weight B A/B
Outputs the net weight at batch finish.
RB
(Req.Batch
status)
Recalls the weighing sequence
status
B H
RTXX (Request Total)
Recalls the accumulated data of
the code designated by XX
B C/D
• When no code designated (blank), total accumulated weight and the total accumulated count will be
recalled.
DTXX (Delete Total)
Clears the accumulation data of
the code designated by XX
A
When no code designated (blank), total accumulated weight and the total accumulated count will be
deleted.
ET (Erase Total)
Clears the accumulation data of
all the codes
A
Both total accumulated weight and total accumulated count are also cleared.
RE (Read EEPROM)
Recalls the data from the
EEPROM
B
• The EEPROM stores data related to calibration and functions.
• The data read out with this command can be exported to other Indicator with the ”WE” command
• This command is available only when
“CAL SEt” is displayed in the calibration mode.
• Data length: 308 characters, ASCII code (terminators not included.)
WE (Write EEPROM)
Writes data (calibration, function)
into the EEPROM
C
This command is available only when “CAL SEt” is displayed in the calibration mode.
RC (Read Code) Recalls the data of all the codes B G
• Set point and accumulation data of the code are read out from the RAM.
• The data of the code number from “0” to “99” and the set point data now in use are output in this
order.
• This command is available only when
“opErAte” is displayed in the set point editing mode.
WC XX (Write Code)
Write data to the code number
designated by XX
C G
This command is available only “opErAte” is displayed in the set point editing mode.
RD
(Read function
Data)
Recalls all the function data D F
This command is available only when “opErAte” is displayed in the set point editing mode.
WD
(Write function
Data)
Write a function data to the
designated code
C F
This command is available when “opErAte” is displayed in the set point editing mode.