Instruction manual

7-1
7. OTHER FUNCTIONS
7-1 Auto Print
Section related:{Appendix C: Function list: SiF—Standard Serial Output Functions: SiF02}
{Appendix C: Function list: SiF— rSF: OP-03 (RS-422/485), OP-04 (RS-232C): rSF -02}
Auto print is the capability to output the Batch Finish weight from the external output configured to
“Auto Print”. The output timing depends on the weighing mode.
Weighing mode Output timing
Customer Programmed Control Mode
• Normal batching
• Loss-in-weigh
Check weighing
The weight is output only once when the net weight is
stabilized at 5D (-5D) or greater. To output again, the weight
should become less than 4D (-4D) once and again has to
reach 5D or greater.
* (-5D), (-4D) are for the Loss-in-weigh weighing.
* D: minimum division
Built-in Automatic Program Mode
• Normal batching
• Loss-in-weigh
• Nozzle Controlled Weighing
The weight is output at the moment when the weighing
sequence encounters the batch finish timing.
7-2 Automatic Accumulation
Section related: {Appendix C: Function list: Sq F—Weighing Sequence Functions: Sq F-02}
The Automatic accumulation function automatically accumulates the net weight after weighing at the
timing described above (same as auto print). Accumulation condition can be selected at Sq F-02.