Instruction manual

6-16
6-9 CALF-14=6 Weighing Mode
(Check weighing 1)
Output signal Output condition
Zero band Gross weight
≤
Zero band
Hi-Hi Hi-Hi limit < Net weight
Hi Target weight + Hi limit < Net weight
Go Target weight - Lo limit
≤
Net weight
≤
Target weight + Hi limit
Lo Net weight < Target weight - Lo limit
Lo-Lo Net weight < Lo-Lo limit
• When an output condition is established, a relevant output terminal is turned on (power continuity with the output
common) or off. “Full flow”, “Medium flow”, and ”Dribble flow”: OFF, the other outputs: ON.
• Select an output terminal at the outF-01-06 setting. See {Appendix C: Function List}.
• Signal is output only in the normal mode. No output in the calibration mode nor function setting mode.