Instruction manual

3-5
Procedures for each mode
Mode # Name Description Display
[0] Mode 0 Retrieves the code number with no set point data set.
 Press [ENTER] to display the code number with no set point data It
returns to the set point editing mode after the action.
* Press [ESC] to select another mode.
“CodE bL”
“SEArch ”
“SET POINT” LED: ON
[1] Mode 1
Writes set point data over the set point designated by a
code number.
 Input a 2-digit code number: “XX” to be copied, “YY” to be
written over.
* Type “0” ahead for a single digit code like “01”.
* Press [F] to choose the set point data now in use.
“--” is
displayed and that means “now in use”.
* Press [+/-] to cancel the input and re-input.
* Press [ESC] to return to the set point editing mode.
 Press [ENTER] to overwrite the data. It returns to the set point
editing mode after the action.
 If the data to be written over (“YY”) has a preset set point,
overwriting is not performed.
“FaiLCoPy” is shown for 2
seconds and the unit a wait to be re-input.
“CodE CP”
“XX to YY”
“SET POINT” LED: Blinking
[2] Mode 2
Clears the set point and accumulation data designated by
a code number.
 Input the 2-digit code number of the data to be cleared.
* Press [+/-] to cancel the input and re-input.
* Press [ESC] to return to the set point editing mode.
 Press [ENTER] to clear the data. It returns to the set point editing
mode after the action.
“CodE dt”
“CLEAr ”
“SET POINT” LED: Blinking
[3] Mode 3 Clears the accumulation data
 Input the 2-digit code number of the data to be cleared.
* Press [+/-] to cancel the input and re-input.
* Press [ESC] to return to the set point editing mode.
 Press [ENTER] to clear the data. It returns to the set point editing
mode after the action.
“CodE tL”
“CLEAr ”
“TOTAL” LED: Blinking