Instruction manual

39
10-4 2D Comparator Mode (By time control)
10-4-1 Setting the upper and lower limit values for each level
1. In the measurement mode, press the HI key or LO key to check the
upper limit value or lower limit value.
2. In the main display, Hi 1 or lo 1 appears. And in the right side
of the sub-display, the upper limit or lower limit value that is currently
set for the level appears. The corresponding z indicator turns on.
ti 5t indicates the starting time. ti end indicates the ending
time.
1> Switches among the upper limit value, lower limit value,
starting time and ending time.
1∧ Increases the level.
1∨ Decreases the level.
1↵ Selects the item to be changed and goes to step 3.
ESC Cancels the operation and returns to the measurement
mode.
3. The value blinks indicating that changes are available. When the
negative value is set for the time, the comparison at the
corresponding level will not be performed. The time unit is ms.
Use the following keys to change the value.
1> Selects the digit to set.
1∧ Increases the value.
1∨ Decreases the value.
+/- Changes the polarity sign
1↵ Saves the changed value and returns to step 2.
ESC Cancels the operation and returns to the measurement
mode.
To return to step 2
4532
1000 400
Hi 1
5et 1000
140
5et t1end
250
5et t1end
HI
ti end
5et 140
+/-
lo 1
5et 400
t1 5t
5et 100