Specifications

1 Common to SOFT MONITOUCH TELLUS and V-Server
1-11
1
Note: Connection in the HMI mode does not support multi-link and multi-link 2.
*1: Only transfer mode 1 is allowed.
*2: Only RS422 is allowed.
*3: In a case where [Trigger: Memory] and [Type: Word] are specified in the V-Server [Event Setting] dialog box, processing is performed in units of one word, even with
䇭䇭a double-word device.
*4: In a case where [Trigger: Memory ] and [Type: Bit] are specified in the V-Server [Event Setting] dialog box, high-order bits (bit 16 through bit 31) of a double-word device
䇭䇭are not usable.
*5: Macro command [PLC_ULR] is not supported.
*6: Only transfer mode type 2 is allowed.
*7: In a case where [Trigger: Memory] and [Type: Bit] are specified in the V-Server [Event Setting] dialog box, PLC memory is not usable.
*8: T-link, OPCN-1, and SX bus are available with V7i only.
*9: If "䂾" is shown and also if "TELLUS HMI 1:1" is marked with "䂦" or "X", the message "Remote mode is not supported." will appear. Ignore the message and go ahead
䇭䇭with the operation.